About ATE Test Head
 | |  | |  |
| 102 South Street Hopkinton,MA 01748 info@testevolution.com 1-781-644-2111 All rights reserved; 2008 Test Evolution Corp |
Information
Corporate
| Test Evolution Test Head |
Test Head
The ATE Test Head contains two 14-slot
AXIe chassis that accept ATCA
cards and one 20-slot PXI chassis that
accepts 3U PXI form factor cards. The
rugged light weight aluminum frame
uses precision locating pins &
bushings to locate and reference ATCA
backplanes, extender cards, load board
and docking assemblies.
The ATE Test Head contains two 14-slot
AXIe chassis that accept ATCA
cards and one 20-slot PXI chassis that
accepts 3U PXI form factor cards. The
rugged light weight aluminum frame
uses precision locating pins &
bushings to locate and reference ATCA
backplanes, extender cards, load board
and docking assemblies.
Docking
The test head accepts a standard
4-point Docking Plate assembly and
probe tower assemblies up to 320 mm
diameter. It can be used with
manipulators using an 358
mm x 314 mm aluminum plates
attached to the frame.
The test head accepts a standard
4-point Docking Plate assembly and
probe tower assemblies up to 320 mm
diameter. It can be used with
manipulators using an 358
mm x 314 mm aluminum plates
attached to the frame.
Load Board
The Test Head accepts a 406 mm x 457
mm Device Interface (load) Board.
Connections to the load board include up
to 4160 Instrument I/O channels, VHDM
DUT power receptacles, and up to 72
Blind-mate SMA coaxial connections. For
easy changeover, a handle
operate mechanical cam follower and
pulley system easily docks and undocks
load board assemblies.
The Test Head accepts a 406 mm x 457
mm Device Interface (load) Board.
Connections to the load board include up
to 4160 Instrument I/O channels, VHDM
DUT power receptacles, and up to 72
Blind-mate SMA coaxial connections. For
easy changeover, a handle
operate mechanical cam follower and
pulley system easily docks and undocks
load board assemblies.
ATE Rack
The test head is used with a EIA
compliant 19” equipment rack. The Test
System requires a 240 Vac, 50/60 Hz, 60
A, Single Phase supply and is internally
protected by circuit breakers. The rack
supplies power to
the test head and contains a 6 1/2-digit
DMM for system calibration.
The test head is used with a EIA
compliant 19” equipment rack. The Test
System requires a 240 Vac, 50/60 Hz, 60
A, Single Phase supply and is internally
protected by circuit breakers. The rack
supplies power to
the test head and contains a 6 1/2-digit
DMM for system calibration.
Test Evolution Corporation
Evolving Technology for Test
